Forum

I am unable to read the routing specifications in German. Is there an English version available?

If not, do I need to radius the corners of a notch on the side of the pcb in the artwork, or can I leave them at right angles |__|. If I am required to draw the radius in, what is the minimum standard specification for inner corners (based on router tool radius?).

Thanks

: I am unable to read the routing specifications in German. Is there an English version available?
:
: If not, do I need to radius the corners of a notch on the side of the pcb in the artwork, or can I leave them at right angles |__|. If I am required to draw the radius in, what is the minimum standard specification for inner corners (based on router tool radius?).
:
: Thanks


Hi Jamie
We use 2 cutter sizes to Rout the boards 1mm and 2mm.
Therefore the inner radius would be 0.5mm and 1mm respectively. If you require any other radius you would have to create it in the board outline. We cannot cut a radius less than the radius of our 1mm rout bit.

Hope this answers your question
Best Regards
Your Pcb-Pool Team