Forum

I want three single sided boards making, each 100x60mm. Therefore you will charge to separate the boards by routing. I also need a slot routing in each board, so the question is, is this included in the first routing charge or not ?
Can I place overlapping pads so that when they are drilled it forms the slot I require? or is this not allowed.
Please excuse my ignorance.
Ian

: I want three single sided boards making, each 100x60mm. Therefore you will charge to separate the boards by routing. I also need a slot routing in each board, so the question is, is this included in the first routing charge or not ?
: Can I place overlapping pads so that when they are drilled it forms the slot I require? or is this not allowed.
: Please excuse my ignorance.
: Ian

Hi Ian
You will only have to pay 1 rout charge. You can define your slots as you suggest or else you can draw them on your board contour layer.

Best Regards
Your Pcb-Pool Team