Forum

I am using the minimum track widths for routing --that being 0.15mm.
Are you capable of manufacture my board reliably?

Is the probability of having broken tracks due to etching or some other process high?

Please note, that I still can't find answers for:
1) min track-to-track spacing.
2) min track-to-via spacing.
3) min track-to-pad spacing.
4) min via-to-via spacing.
5) min via-to-pad spacing.
6) min pad-to-pad spacing.

It would be extremely helpful for me if you could state these parameters for me. Also, I believe this would be beneficial to anyone else following your FAQs.

Many thanks,
Paul.

: I am using the minimum track widths for routing --that being 0.15mm.
: Are you capable of manufacture my board reliably?
:
: Is the probability of having broken tracks due to etching or some other process high?
:
: Please note, that I still can't find answers for:
: 1) min track-to-track spacing.
: 2) min track-to-via spacing.
: 3) min track-to-pad spacing.
: 4) min via-to-via spacing.
: 5) min via-to-pad spacing.
: 6) min pad-to-pad spacing.
:
: It would be extremely helpful for me if you could state these parameters for me. Also, I believe this would be beneficial to anyone else following your FAQs.
:
: Many thanks,
: Paul.


Hi Paul,
The answer to you first question is yes.
We can reliably produce track widths of 0.15mm.
Our minimum gap requirments are also 0.15mm.
Please take a look at the following link from our website for more information.
http://www.pcb-pool.com/download/spezifikation/eng_e_technik.pdf

Thank you for you interest in Pcb-Pool
Best Regards
Your Pcb-Pool Team

Hi Paul,
I use OrCad Layout myself.
The settings you require are as shown in the main ordering page as Min. Track/Gap Size.
I would normally use 0.2mm / 8thou for all my settings as other manufacturers charge a premium for smaller sizes (minimum track width and the via-via spacing etc).
Here the standard is a minimum of 0.15mm / 6thou or a smaller 0.125mm / 5thou spacings and tracks.
Regards
Tony