Forum

Hello,

I have been searching the forums and the site, but I have not found the answer. I see that the minimum drill diameter for PCB-Pool standard service is 0.3mm, and the maximum is 6mm. I would like to know the sizes of the other standard drills on this rack.

Sorry if I overlooked the answer in my research.

Thanks,
Craig

Hi Craig,
You can request any drill size from 0.3mm to 6.0mm in increments of 0.05mm.
If you require a drill size greater than 6.0mm then a rout charge will apply.
Please also have a look at the attached spec sheet for our drilling tolerances.

Best Regards
Your Pcb-Pool Team