Forum

Hi:

I'm working in a high speed board, then I have to control the maximum length on each path. I'm using ORCAD 9.0. What can I do to set the minimum length of the via in my board before to use the autoroute tool?.

Additionally, is it possible to set the length to be the same for a set of nets?

Thanks for your kind attention.
Jose Luis S.

: Hi:
:
: I'm working in a high speed board, then I have to control the maximum length on each path. I'm using ORCAD 9.0. What can I do to set the minimum length of the via in my board before to use the autoroute tool?.
:
: Additionally, is it possible to set the length to be the same for a set of nets?
:
: Thanks for your kind attention.
: Jose Luis S.


Hi Jose,
Thanks for your interest in Beta LAYOUT and the PCB-POOL(R).
We are sorry to say that we cannot answer your question with full confidence, so please chack out the link below.
http://www.orcadpcb.com/layout/layout_faq.asp?bc=F
In our PCB-POOL(R) service the minimum via is 0.3mm in diamatre.
Thanks again
Your Beta LAYOUT Team