more on panel
Thanks for your quick reply to my question
A apologize for coming again with the same topic, but I
want to check that I have correcly understood :
Let us assume that I need a set of small different
boards, but that I do not need them to be hold together by pips.
Is the following scheme correct :
1) I create a GCPrevue file for each board, each one with its own outline drawn on the outline layer
2) I pack them together, for example in a zip file
3) I fill a single order, giving dimensions corresponding to the total area (greater than 1 dm2)
4) I put some explanations in the Special Requirements,
saying how many I want of each board.
As a result I will be charged for the total area, plus 12 eur for routing, plus eventually 17 eur per side for solder mask and 17 eur for silk screen, Ok ?
Regards, Jean-Louis
A apologize for coming again with the same topic, but I
want to check that I have correcly understood :
Let us assume that I need a set of small different
boards, but that I do not need them to be hold together by pips.
Is the following scheme correct :
1) I create a GCPrevue file for each board, each one with its own outline drawn on the outline layer
2) I pack them together, for example in a zip file
3) I fill a single order, giving dimensions corresponding to the total area (greater than 1 dm2)
4) I put some explanations in the Special Requirements,
saying how many I want of each board.
As a result I will be charged for the total area, plus 12 eur for routing, plus eventually 17 eur per side for solder mask and 17 eur for silk screen, Ok ?
Regards, Jean-Louis
04.04.2007 15:55:19